
SINGLE SCREW EXTRUDER GEAR UNITS
Our gear units for single-screw extruders are utilised in all areas of extrusion – be it for film, sheet and recycling material, or for the food industry or for animal feed. This is only possible due to the high versatility of the single screw extruder gear units, all variants of which can be integrated into the extruder: vertical or horizontal, Z or U configuration, motor above or below. Everything is possible – even setups where the screw can be removed from the rear can be incorporated into the design.
Eisenbeiss single screw extruder gear units are designed precisely to meet customer specifications.
TECHNICAL DATA
SERIES: EEX
POWER RATING: 100 to 1,000 kW
OUTPUT TORQUE: 10,000 to 70,000 Nm
OUTPUT SPEED: 60 to 130 rpm
RATIO: 6 to 25
LUBRICATION / COOLING: splash or forced-feed lubrication with optional oil lubrication unit
SCREW BACK PRESSURE: up to 500 bar continuous load
SCREW DIAMETER: 100 to 350 mm
POWER RATING: 100 to 1,000 kW
OUTPUT TORQUE: 10,000 to 70,000 Nm
OUTPUT SPEED: 60 to 130 rpm
RATIO: 6 to 25
LUBRICATION / COOLING: splash or forced-feed lubrication with optional oil lubrication unit
SCREW BACK PRESSURE: up to 500 bar continuous load
SCREW DIAMETER: 100 to 350 mm
ADVANTAGE
Extreme efficiency improvement using a special lubrication system to achieve high energy efficiency. Using low pressure, gravity and cascade lubrication, the oil is where it is needed for lubrication. As a result, oil splash losses are reduced, no external cooling is required and oil quantities are reduced to a minimum. The energy saving Eisenbeiss gear unit is protected by a patent.
APPLICATION
RECYCLING
Improving the efficiency of the gear system not only helps save valuable energy, but operating costs as well.